First read and observe the introductory information and safety warnings
Main beam control (Light Assist)
The main beam control switches the main beam on and off again automatically within the limits of the system depending on environmental and traffic conditions as well as travelling speed . The function is controlled by a sensor located on the inside of the windscreen above the interior mirror.
Automatic main beam control (Dynamic Light Assist)
The automatic main beam control (Dynamic Light Assist) can, working within the limits of the system, minimise or even stop dazzling of other road users .
The system identifies other road users as well as their distance from own vehicle and covers part of the headlights appropriately to prevent disturbing other road users. If dazzling other road users cannot be prevented, the light distribution is automatically set to dipped beam headlights. The function is controlled by a camera located at the base of the interior mirror.
The automatic main beam control automatically switches the main beam on as of speeds of approx. 60 km/h and off again at speeds under approx. 30 km/h depending on whether there are vehicles ahead, whether there is oncoming traffic and also on other general and traffic conditions.
If the dynamic bend lighting is deactivated or the headlight switch-over is activated, the full beam lights are only switched on and off automatically. This is done depending on the vehicles ahead, oncoming traffic and the road lighting.
Switching on and off
|Switching on:||- When the ignition is switched on, turn the light switch to the position and tap the turn signal and main beam lever to the main beam position . When the main beam control or the automatic main beam control is activated, the indicator lamp in the instrument cluster display lights up.|
- Switch ignition off.
вЂ“ OR: turn the light switch to any position other than .
вЂ“ OR: tap the turn signal and main beam lever to the headlight flasher or main beam position .
It may not be possible to switch off the main beam quickly enough or at all using the main beam control function due to the following:
WARNINGDo not let the extra convenience afforded by main beam control or automatic main beam control tempt you into taking any risks when driving. The system cannot replace the full concentration of the driver.
The headlight flasher and the main beam can be switched on and off manually at any time with the turn signal and main beam lever .
Volkswagen Touran Owners Manual. Driving through water
First read and observe the introductory information and safety warnings Please follow these points in order to prevent damage to your vehicle when driving through water, for example on flooded streets: Check how deep the water is before driving through it. The water may be no high ...
Volkswagen Touran Owners Manual. Introduction
This chapter contains information on the following subjects: в†’ Storing вЂ‰ в†’ Contents вЂ‰ Observe any country-specific legislation when securing your vehicle in the event of a breakdown. Additional information and warnings: Preparation for working in the engine compartmen ...