VW Touran manuals

Volkswagen Touran Service Manual: 6-Pin Universal Oxygen Sensor, Removing and Installing

Volkswagen Touran Service Manual / Electrical System / Wiring / Heated Oxygen Sensor, Replacing / 6-Pin Universal Oxygen Sensor, Removing and Installing

  Note
Use the faulty sensor as a guide for installing all of the accompanying attachments, cable ties or marking bands.
Do not crimp or cut the wires otherwise the functionality of the heated oxygen sensor (HO2S) will be diminished.
  Remove the old heated oxygen sensor (HO2S).
   
  Lay both of the oxygen sensor next to each other so the sensor housings are the same level.
  6-Pin Universal Oxygen Sensor, Removing and Installing
  Tie the excess length of the sensor (approximately 50 to 250 mm) back so it is the same length as the faulty sensor and secure it with cable ties -1-.
  Install the new oxygen sensor in the vehicle.
  6-Pin Universal Oxygen Sensor, Removing and Installing
    4-Pin Heated Oxygen Sensor (HO2S), Removing and Installing
      Note Do not repair the heated oxygen sensor wires. Repairing may result in malfunctions. Use the faulty sensor as a guide ...

    Oxygen Sensor Unit Protective Pipes
      Note In addition to using the part number, the protective pipe can also be used for identification. Version D1, 6 openings, 3.5 mm eac ...

    Other materials:

    Volkswagen Touran Owners Manual. Warning lamps and indicator lamps
    First read and observe the introductory information and safety warnings  Lit up Possible cause Correction Engine oil level is too low. Switch off the engine. Check the engine oil level   . ...

    Volkswagen Touran Owners Manual. Underseal
    First read and observe the introductory information and safety warnings The underside of the vehicle is coated to protect it from corrosion and damage. The protective coating on the underside of the vehicle could be damaged when driving. Volkswagen recommends therefore that the protective ...

    2017-2022 © Copyright www.sooja.site